The points and areas marked in blue must be observed and worked on.

Bearings in the carrier are secured fourfold (centre punch point) against rotation.
Note the installation position of the bearing in the wheel carrier and secure it against rotation with a grub screw (M8) and Loctite.

The circlip must be visible to the rear. Machine the blue surface for free movement of the wishbone.

Installation position for track rods spacer HA outside (wheel carrier side)
Install the eccentric bolt from the top, the pinch nut from the bottom.

The small blue line at the top at 12 o'clock position at the small HA stand is the exact installation position for the eccentric uniball bearing!

Front axle strut uniball bearings

The blue collar on the bearing and retaining ring must point towards the rear of the vehicle when installed on all F models.

Fit the grub screw (M8) with Loctite at the top in the 12 o'clock position to secure against twisting.